| PRODUCT DESCRIPTION:
Two component 100% solid pure aromatic polyurea (PUA)
ADVANTAGES & BENEFITS:
Fast set curing system (5-6sec gel time; 15sec tack-free time)
Seamless coating
Very good chemical resistance
No VOC’s and no odors
Ambient moisture insensitive during application
Application until -20°C (-4°F)on site
Short down time
SUBSTRATES :
Concrete, iron, steel, wood, asphalt layer, tiles, geotextile non-woven fabrics, sprayed
polyurethane or PUR slabs foam, EPS/XPS (polystyrene).
SUITABLE FOR:
General purpose waterproofing
Waste water tank coating
Secondary containment
Pedestrian and vehicles flooring (avoiding to make a finishing floor with tiles)
New internal and external industrial flooring
Restoring old internal and external industrial flooring
Restoring old asphalt layer without their removing
Swimming-pool coating
Notes:
In case of swimming-pool, finishing should be done with an aliphatic polyurethane
paint like ELACOLOR.
WAY OF APPLICATION:
Spraying or pouring with a suitable high pressure and high temperature plural
component equipment
SUBSTRATES PREPARATION
Concrete:
Before application check surface must be dry (internal moisture not above 10%),
cleaned and structurally sound. In case of new concrete check the surface must be
without bugholes and do not apply PUA before 28 days from casting of concrete. In
case of application on new or to restore ground floor be sure of the presence of a
vapor barrier.
Steel or wood:
surface must be cleaned, dry and with coarse profile (sandblasting or shotblasting).
Ceramic tiles:
surface must be cleaned, dry, shotblasted, scarified or it should be coarse by acid
etching and with restored seams.
Other kind of surfaces: please consult our technical office.
In any case we suggest (except for restoring of old asphalt layer) to apply a thin layer
of primer EDILPRIM PU one component solvent based pur primer or EDILPRIM EP
three-component waterborne epoxy primer. | |
|
Products